AT&T Definity 8410D Guida Utente Scaricare il pdf (Pagina 39)

To cancel Send All Calls

If you are using an 8410 with a display, press [

Menu ]

and then press the softkey below SAC again

(while on-hook)

If your 8410 does not have a display or if SAC is not

available on your display, press [

Send Calls ] again

(while on-hook)

or Dial Send All Calls cancel code

(while on-hook)

[confirmation tone]

Speaker

Note: Your voice terminal is set for either the Speaker (listen-only) or the

Speakerphone (listen and talk) function. Check with your system manager to see

which of these two features you can use.

You can use the Reset Speakerphone feature only if your voice terminal is set for

Speakerphone (listen and talk).

Use the following procedures if your voice terminal is set for the Speaker

(listen-only) feature.

To place a call without

lifting the handset, or to

use speaker with any

listening-only feature

activity (such as,

monitoring a call on

which you have been put

on hold or for group

listening)

Note: In order for the

other party to hear you,

you must speak through

the handset.

Press [

Speaker

]

●

Red light next to [ Speaker ] goes on; red light next

to [

Mute ] goes on

Place call or access selected feature

Adjust speaker volume if necessary

●

To raise the volume, press the right half of the

Speaker Volume control button labeled [

∧ ] ;

to lower the volume, press the left half of the

Speaker Volume control button labeled [

∨ ]

If you have a display, it shows

SPEAKER L>>>>> H

(There are eight possible volume settings. On the

display, one arrow is the lowest setting, and eight

arrows is the highest setting)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 56 57

Commenti su questo manuale

Nessun commento

AT&T Definity 8410D Guida Utente Pagina 39

Commenti su questo manuale

Prodotti e manuali riguardandi Networking AT&T Definity 8410D